不少測力計的使用者在用數顯測力計的時候通常會遇到的一個問題，那就是數顯測力計出現測量不準確，大部分測力計用戶都不明白其中的原因，下面就由實干數顯測力計小編來為大家介紹下數顯測力計出現測量不準原因。
Many users of the dynamometer usually encounter a problem when using the digital display dynamometer, that is, the measurement of the digital display dynamometer is not accurate, most of the users of the dynamometer do not understand the reasons. The following is a small part of the dry digital display dynamometer to introduce the reasons for the inaccurate measurement of the digital display dynamometer.
其實導致數顯測力計測量不準原因主要有兩個：
In fact, there are two main reasons for inaccurate measurement of digital dynamometer:
一、沒有正確的使用數顯測力計：
1、 No proper use of digital dynamometer:
1、對數顯測力計造成*大傷害的是，在測試的時候千萬不能超出它的測量范圍，不能做推或拉兩種方向以外的負荷試驗。
1. What does great harm to the digital dynamometer is that it must not exceed its measuring range during the test, and it is not allowed to conduct load test beyond push or pull directions.
2、當測試桿在未接任何測試頭時候，不能將被測負荷直接作用在測試桿端。
2. When the test rod is not connected with any test head, the measured load cannot be directly applied on the end of the test rod.
3、請不要使用損壞或彎曲變形的測試頭，這樣造成誤差是在所難免的。
3. Please do not use the damaged or bent test head, which will inevitably cause errors.
4、請不要將數顯測力計經常用在測量超過*大測試負荷的負載，否則負荷檢出機構的彈性力將會逐漸劣化，導致檢出的負荷值無法達到要求的準確度等級。
4. Please do not use the digital display dynamometer to measure the load exceeding * large test load, otherwise the elastic force of the load detection mechanism will gradually deteriorate, resulting in the detected load value unable to reach the required accuracy level.
5、在使用數顯式數顯測力要注意，使用之前檢測電池電壓是否正常，如果欠壓請及時充電，否則測量會出現偏差。
5. Pay attention to the use of digital display force measurement timing. Before use, first check whether the battery voltage is normal. If the battery voltage is under voltage, please charge it in time, otherwise the measurement will be biased.
二、沒有定期的對數顯測力計進行保養和維修：
2、 There is no regular maintenance and repair for the digital display dynamometer:
1、由于數顯測力計是用電能供應能量的，因此如果長期不使用時，應定期給測力計充電。
1. Since the digital display dynamometer uses electric energy to supply energy, if it is not used for a long time, it should be charged regularly.
2、每次使用玩數顯測力計就把它裝進箱子里面放到室溫的地方，千萬不能放在有陽光的地方暴曬。
2. Every time you use a digital dynamometer, put it in a box and put it in the room temperature. Never put it in the sun.
3、數顯測力計存放的地方如果是潮濕、不通風的，那麼就會造成儀器遭到銹蝕、損壞。
3. If the place where the digital dynamometer is stored is damp and airless, the instrument will be rusted and damaged.
如果你覺得以上兩種辦法還不能數顯測力計測量不準原因的話，可以來電反饋給我們，我們可以幫你哦！
If you think the above two methods can't solve the problem of inaccurate measurement of digital display dynamometer, you can call us for feedback and we can help you solve it!
